Cleans any size plug without changing grommet. Has 2-way valve (blast or air) and comes complete with abrasive powder. Ready to use. |
1 LB CLEANING ABRASIVE ( BLACK DIAMOND ) X-FINE 600 GRIT
works great!!
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
Seems to work fine. Good tool for the money
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
Works good!
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
mounted upright as directed, it worked and did the job as advertised
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
This works ok. It just longer than the expensive cleaners.
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
1 LB CLEANING ABRASIVE ( BLACK DIAMOND ) X-FINE 600 GRIT
I found this abrasive compound too aggressive to clean the spark plugs. Will have to purchase something less abrasive so I can have a better control of the cleaning process.
1 LB CLEANING ABRASIVE ( BLACK DIAMOND ) X-FINE 600 GRIT
Good little blast cleaner. Just be careful to not blast too much. The black diamond is very much abrasive. Also if you are going to keep it in your tool box close the input air pressure fitting with a cap. Otherwise you will end up with abrasive compound all over your box! LOL
SPARK PLUG CLEANER 2-WAY BLAST OR AIR
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The abrasive that our supplier uses is "Black Diamond", which is an industrial abrasive that does not break down as glass beads tend to do. It will clean without leaving any residue (glass dust) or build up on the plugs.
The abrasive goes in the cavity closest to the air inlet.
The unit will have a bag of abrasive and a nipple fitting for the air inlet.
Extra abrasive can be purchased using part number 12-00787.
It is designed as a one size fits all. Just push the sparkplug through, but it is just a rubber grommet, and can be cut if the user chooses to do so.
No. For the fine wire plugs you will need the walnut abrasive. It will need to be set up as a special order. Please request this through one of our sales team members.
Requires 40 PSI
We have added the Instructions PDF in the Documents tab on this web page.
The abrasive stays in the bag and you reuse it until it shows signs that it is no longer cleaning the plugs.
Yes, our part number is 12-05308