Lever Type - Twist-Knob Without Starter Position.
(diode not required) Made in USA |
Works as advertised. I installed in an RV4 my father built and it required a mounting plate but replaces the old switch and works well.
IGNITION SWITCH A-510-1
I purchased this because I own a seaplane and dont want to become stranded on a lake somewhere because i lost my keys... Besides, airplanes dont NEED keys.. the ignition switches are so cheaply made that they can be forced or picked by ANYTHING. So they really dont provide much security at all. I am opting to have a hidden start button that the thief would have a hard time finding AND... putting in a SECOND Master switch that will provide PRIMARY power to the aircraft.. thereby slaving the traditional Master switch. in other words, if you climb in and flip the master... nothing will happen... You have to flip the second master switch first. It will be hidden in plain sight in another location and not look like a master. The odds that a would be thief would take the time to figure all this out (which they probably could NOT because no other aircraft has anything like that...) is slim to none... In addition, I will NOT use the decal indicating off, L, R, and BOTH positions.. Therefore.. the would-be thief, wont even know for sure that this new switch IS the MAG switch.. so more for them to figure out... and for ME? I hop in... flip master one and two.. turn the MAG switch and push the start button... no keys to fiddle with (or lose) ever again. The unit is well made and works well, the knob is removable with two set screws so that it will not work loose from the torque required when using it.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The A-510-1 switch is rated to handle up to 0.5 amp. Also, we have added a drawing to the "Drawing" tab showing some general dimensions of the switch.
The current through the "L" and "R" terminals is less than 0.5 amps and the open circuit voltage is 300 volts. There are no specs available for the contact resistance.
No, this switch is intended for use in experimental aircraft only.
This has 3 connectors.
No, it is made for experimental aircraft only.
We have added a high resolution photo of the back side of the item to the product page for review.