Good product, however if you have V Brace installed youll need to get them directly from Plane Plastics without the caps glued on. These ones come with the caps glued on and arent able to be installed unless you remove the V brace.

Kirk M Verified Purchase

CESSNA VENTUBE

Should have done this years ago. Seals well. Easy install.

Thacker A Verified Purchase

CESSNA VENTUBE

Great product

Richard D Verified Purchase

CESSNA VENTUBE

Perfect fit and and simple installation in our 49 C-170.

Mark M Verified Purchase

CESSNA VENTUBE

Installation was very easy. They seal up great in the cold air and provide higher velocity airflow in the summer. STC paperwork included.

Easy installation and stay locked in flight Nice

Installed into my Cessna 150. They work great. Drilled a hole into the plastic for the outside air temperature thermometer on the passenger side and it easily fit. Took about an hour or so to install under the direction of an A&P who signed off on the alteration.

Easy install, works as advertised would definitely recommended or buy again

These look to be PERFECT replacements for the drafty old Cessna vent tubes. Looking forward to a war cabin!

Just installed this kit on my Cessna 150. Hardest part was access to where the holes needed to be drilled through the existing housing and into the inner sleeve. Then getting the small screw into the hole. Took about an hour total. Removed the thermometer from the old vent and installed in the new vent with no issues. Test flown and it works well. Moves air when open and nothing gets through when it is closed. The post in the back keeps it closed. No more drifting open.

I just recently installed the Ventube as a replacement for my Cessna 170s old aluminum type vents. The Ventube consists of an outer tube that gets fixed against the metal air tube with a small stainless screw and a washer as well as an inner tube that fits quite tight in the outer tube. Installation was a breeze (one hour in a very cold hangar). The Ventube is really airtight if you close it completely. With a small velcro patch (included) you can create a little more friction between the two tubes which enables that the inner tube can be adjusted to any position and will stay there. A 100% must buy!

Much better than the old tubes. You do have to be careful when drilling in the retaining screw. Without a couple of washers on the outside of the wing tube the supplied screws will prevent the inner tube from sliding in. We also found that one layer of electrical tape made the perfect gasket around the outer tube so that it sealed perfectly within the wing tube.

Nice units but they need to extend further out into the windscreen. They are too short to get air to the rear seat PAX!